One of the early steps in making the RF Board is to check that the physical connections to the Front Panel and the Filter Board are OK. It was satisfying to have them plugged together, even if only briefly.
25 March 2007
K1 - First steps on the RF Board
It's been busy at work over the past week, so not much time for the K1. I have made a start on the RF Board. No problems so far, but lots of capacitors with very small markings. I'm glad that I have a digital meter for measuring capacitance and inductance (the L/C Meter IIB from AADE) as well as my old multimeter for resistance. It makes it quick to double check each component before I install it.
One of the early steps in making the RF Board is to check that the physical connections to the Front Panel and the Filter Board are OK. It was satisfying to have them plugged together, even if only briefly.
One of the early steps in making the RF Board is to check that the physical connections to the Front Panel and the Filter Board are OK. It was satisfying to have them plugged together, even if only briefly.
Subscribe to:
Post Comments (Atom)
-
Did some testing with the IMD Meter in my garden near my HF antenna. Field strength was either zero or full scale. IMD was either 'no ...
-
Here it is, a combination of the "Practical 7MHz Hartley Oscillator" from Experimental Methods in RF Design (page 4.3) and a buffe...
No comments:
Post a Comment