31 March 2007

K1 - Really looking like a radio

After some more work on the RF Board, including winding a couple of transformers, I got to the point where I could attach the case sides, and plug in the front panel. Then I only needed to add a coax cable link on the back of the RF Board and it was time to power on and carry out initial testing and configuration. Everything went smoothly; sidetone works, the keyer works, I can change band! Next step is completing the VFO.

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Hello again

Fifteen years later and I finally post something new 😀 I am keeping this blog as an archive and have started a new one for my current activ...

  • Now I'm confused
    Did some testing with the IMD Meter in my garden near my HF antenna. Field strength was either zero or full scale. IMD was either 'no ...
  • Ugly VFO circuit diagram
    Here it is, a combination of the "Practical 7MHz Hartley Oscillator" from Experimental Methods in RF Design (page 4.3) and a buffe...