Major milestone. I've reached the bottom of page 41 in the manual where, in small italics, it says "This completes received alignment" :-)
Completing the VFO was fairly trouble free. I could not get the VFO into the required range with L1 as wound (even with spacing out the turns as far as they could go). So I followed the advice in the manual and took one turn of L1. Aligning the Filter Board went much more smoothly, using my FT-847 into a dummy load as a signal generator.
Most radical thing I've done is choose a sidetone frequency of 600Hz. My other rigs are set up for 800Hz but I thought I would try something a bit lower. Maybe it is age affecting my hearing.
No comments:
Post a Comment